- Mon Nov 11, 2019 2:21 am
If it is the same material as the other walls, lower it's Intersection Priority so that it does not cut the walls that you are keeping. Though I believe that this will not fix all of your wall contour lines, but it will prevent there being a hole in your toilet wall, 2D fill and 3D.
If the Building Material of the removed wall is high than that of the retained, reduce the Building Material Strength of said Building Material, or turn off auto-intersection and do not intersect the reference lines of your removed wall with the retained. With these two, the Building Material change will have a similar result as the Intersection Priority change mentioned before while the Auto-intersection change will give you a thicker line cutting the joint between the two walls when you show existing.
Alternatively, and probably better, would be to put the removed wall on a separate layer and have that layer change Intersection Group between an existing and planned Layer Combination. This would be the best option as far as I know, but I do not work on renovations so there maybe a better way.
AC18-23 AUS 4006
Self-taught, bend it till it breaks.
Win10 | E5620 x 2 | 24GB | K2200