The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Sections/Elevation/3D Document/Worksheets/Details etc., Annotations, Texts, Labeling, Autotext/Project Info, Layouting, Renovation Filters, Graphic Overrides, Revisions/Issues, Printing/Plotting, PDF, Mark-Up, etc.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

#308623
Hi all,


I'm trying to find an efficient way of making a floor plan that shows codes/colors for interior surfaces.

These plans basically look like the picture under. They're like a stripped down version of a normal plan, with a thick colored line symbolizing the wall surface type and which side of the wall the surface is supposed to be on.

I would prefer to do this plan without drawing any extra lines in 2D. Is there some way I can override line type and pen color of composite wall skins/separators with graphic overrides or changing pen sets? I would not like to model x amount of composites for each and every different wall/surface combination.


Image
#308679
Braza wrote:
Mon Mar 23, 2020 6:38 pm
You could create a dedicated penset for this and use GO to change the CP composite line.
Hope that helps.
That is a good suggestion, thank you. Could you clarify what you mean by CP?

I assume the GO would change line types on both sides of the wall to be the same. Ideally i would have different lines/line types on each side of the wall.
#308739
CP is for Complex Profile.
Ok. Now I understand what you are trying to achieve.
You want to control individual lines on a CP by GO.
As you well said, GO change all of them. So it is not possible.
Perhaps some tweak on the Zone tool could do the trick. :?:
Hope that helps.