The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Sections/Elevation/3D Document/Worksheets/Details etc., Annotations, Texts, Labeling, Autotext/Project Info, Layouting, Renovation Filters, Graphic Overrides, Revisions/Issues, Printing/Plotting, PDF, Mark-Up, etc.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

By Kamelite
#309888
I'm pretty sure this is a simple thing, I just can't seem to figure it out.

In the picture below, I have an elevation, and I need to label those windows with dimensions. So far so good. But I want to display them as decimeter-values, so that the label shows 10*19 instead of 990mm*1880mm..

[attachment=0]vindusdimensjoner.jpg[/attachment]

How do I make this happen?

.Thnx, Kamelite
Attachments
vindusdimensjoner.jpg
User avatar
By David Maudlin
#309890
Kamelite:

If that is the Dimension Label 23, go to the Symbol Label Custom Settings > General Settings... tab, it has Show Units > Linear > mm, cm, dm, m, inch and by Project Preference options.

David