The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Sections/Elevation/3D Document/Worksheets/Details etc., Annotations, Texts, Labeling, Autotext/Project Info, Layouting, Renovation Filters, Graphic Overrides, Revisions/Issues, Printing/Plotting, PDF, Mark-Up, etc.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

By joimagg
Is it possible to have a zone stamp always centered vertically and horizontally inside the zone?

This is possible with the "Area Text" in Fill...and its such a nice feature when doing quick zone sketches.

Kind Regards
User avatar
By Marc H
I'm not aware of an auto setting, but it will place the stamp where you confirm (hammer) the room. Typically, I pick the center of the geometry or, if equipment, casework, and/or furniture is visible, in a clear area of the floor.

If I have a line of spaces and want the stamps to line up, I will either set a guideline before or after the first placed stamp, or I will drag copies and then go back and edit the zone id.

Hope this helps.