TISSOT_1853 wrote: ↑
Fri Dec 07, 2018 12:10 pm
Noticed that the processor much load favorites based on complex profiles. For example-a round pipe with about 80 points. But another method of plotting radius curves GRAPHISOFT has not yet offered us
Thank you for sharing this with us and everyone else. We have added a wish into our database to address this. Its reference number is Wish #12586.
Hopefully, it will be implemented in the future.
If you happen to be using these pipes vertically, perhaps using columns where the core is let's say Air and the Veneer can be something else, then this would offer you the ability to modify them in a parametric way.
Sadly, this option does not apply for beams.
If you happen to have MEP modeler, I would suggest using it as it can achieve a similar result.
We have added a wish to allow Veneers to be applied to beams as well just to be thorough, and it can prove to be a good feature.
Till then, I wish you all a happy new year and a great day!
For Troubleshooting and useful Tips & Tricks visit