The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Modeling and drafting in Archicad. (Example: How can I model a Roof soffit/fascia?)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

#312918
valar morghulis. u can understand my problem in attached file.
*i tried layer priorities, not working.

want to show other wall in 3d.
:?:
Attachments
Screenshot_2.png
Screenshot_3.png
Screenshot_4.png
#312919
found a solution here. viewtopic.php?p=312735#p312735.
Code: Select all
The issue could be the Intersection Priority (IP) of the Building Material (BM). It looks like the Wall IP is greater than the Roof, so the Roof is getting cut before the SEO is evaluated.
#312928
Yes for automatic trimming (Priority Based Connections), the strongest Building material will dominate.

Otherwise you have to resort to manual trimming which can sometimes be tricky as walls will automatically try to connect reference lines, unless you specifically cut/split them where you want and delete the bits no longer needed.


Barry.
#312992
Or, if you do not want to modify the Intersection Priorities of Building Materials, you can also select the Wall the End Surface is showing on the surface of the other Walls, and check the "End Surfaces: Override using Adjoining Walls" checkbox.
On the following image, on the left, the thicker Wall has this checkbox checked, on the right, it does not.

Wall_EndSurfaceOverride.png