The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Modelling and drafting in ARCHICAD. (Example: How can I model a Roof soffit/fascia?)

Moderators: ejrolon, Barry Kelly, Karl Ottenstein, LaszloNagy, gkmethy

#296730
I probably knew the answer to this at one point, but baffling me now.

I have interior walls that are trimmed by a roof above. But the cut is apparently occurring at the top/exterior plane of the roof, rather than the bottom interior side of the roof. Thus, I am seeing the "footprint" of the walls on the top of the roof where I should be seeing uninterrupted roof finish material.

I get the desired result when using conventional SEO operations, but the "trim elements to roof/shell" is easier to use, and I'm accustomed to getting the desired result with that command.

What I am overlooking?

Thanks.
#310347
Thanks, David and Dontknow. I just spaced out for a second there. When you've been using ArchiCAD since v4, every feature that came since then still seems new, and I forget about them! Obviously, material priorities were a very welcome improvement when they showed up.