The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Modelling and drafting in ARCHICAD. (Example: How can I model a Roof soffit/fascia?)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

By Bill
#303603
I am trying to create a typical basement-type stair, where the wood treads sit on top of the wood stringers. I cannot figure out in the stair tool how to create this... when I set up the stair, the only option I see for stringers is for them to be located on the sides of the stair, and the treads are set into the sides. What am i missing? Is there a setting to offset the stringer locations?

Thanks!
#303613
Instead of the 'Stringer" flight/landing, try using the 'Beam' type.
The beam sits under the treads, and you can use the 'Open Stringer 22' beam.

Barry.
Attachments
stair_stringer_under.jpg