The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Modeling and drafting in Archicad. (Example: How can I model a Roof soffit/fascia?)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, Gordana Radonic, nbalogh, mnguyen, gkmethy

By qbic-ft
#320531
If one inserts a base cabinet with a sink (24" deep for example) and then you extend the countertop on the back let say by 18", suddenly the cabinet changes the depth to 28.5" and it doesn't let you go less than that dimension. I wanted to make a kitchen island with 42" depth countertop and I got that issue.

Fernando
User avatar
By mnguyen
#320724
Dear Fernando,

First of all, Happy New Year! May it bless you with health, wealth, and happiness!

Thank you very much for the question!

Could you let me know which Archicad version and language you are using? To replicate the issue, could you share with me the name of the object? Some screenshots/short videos about how to reproduce the issue would be extremely helpful in this case!

Looking forward to hearing from you!

Best regards,
Minh
By qbic-ft
#321336
Hello,

Sorry for the delay. Happy new year to you as well.

I'm using AC 24 US version.

The cabinets are the same object. The one on the left the sink is off and if you notice the settings of the right cabinet the minimum depth is 2'-8 3/4"... This only happens when you extend the counter.

cabinet.jpg
cabinet.jpg (205.02 KiB) Viewed 77 times
mnguyen wrote: Mon Jan 04, 2021 1:28 pm Dear Fernando,

First of all, Happy New Year! May it bless you with health, wealth, and happiness!

Thank you very much for the question!

Could you let me know which Archicad version and language you are using? To replicate the issue, could you share with me the name of the object? Some screenshots/short videos about how to reproduce the issue would be extremely helpful in this case!

Looking forward to hearing from you!

Best regards,
Minh
User avatar
By mnguyen
#321414
Hi Fernando,

Thank you very much for your screenshot!

Unfortunately, after many attempts, I am still unable to reproduce the issue, as you can see in the screenshot below:
Image

The minimum depth is still around 1'.

Could you help me to make a small video/gif of how you create this issue?

Thank you very much!

Best regards,
Minh