The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Modeling (Wall, Door, Window, Roof, Stair...), Favorites...

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

What is your opinion about this Wish?

Essential
No votes
0%
Important
No votes
0%
Average
No votes
0%
Not Important
No votes
0%
Not Needed
No votes
0%
#296365
I would like to see the wall tool enhanced or a new wall end tool to allow wall lap junction and the slab have a edge interface to allow lap junctions on all edges. Lap junctions are used in cross laminated timber construction.

At the moment to get the panels correct showing composites you have to use morphs. However morphs exponentially increase video card usage and make the model difficult to navigate in 3D.