The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Any 2D tool what you need for drafting.

Moderators: ejrolon, Barry Kelly, Karl Ottenstein, LaszloNagy, Gordana Radonic, nbalogh, gkmethy, mnguyen

What is your opinion about this Wish?

Essential
8
80%
Important
1
10%
Average
1
10%
Not Important
No votes
0%
Not Needed
No votes
0%
#324694
mnguyen wrote: Thu Apr 15, 2021 1:04 pm But your input also raises a question: if a column is set as Zone boundary, should the Zone tool recognize it when using Inner Edge method?
Of course it should! No doubt there.
#324700
Yes, it should.

But Mihn, did you try this with AC24? From the icon color in the upper left corner of that Warning Box, it seems like AC22.
It works fine for me in AC24.
#324725
Hi Laci,

I tested with AC24 and got the same warning. I looked back at our User Guide, it is clearly stated that:

Inner Edge method: ARCHICAD defines the zone area by the inner edges of walls.

Anyhow, let's not drive this further away from the Magic Wand topic ;) I agree that the Magic Wand should be able to recognize the contour better.

Best regards,
Minh