The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Any 2D tool what you need for drafting.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, Gordana Radonic, nbalogh, mnguyen, gkmethy

What's your opinion about this wish?

Essential (5)
Important (4)
Average (3)
No votes
Not important (2)
No votes
Not needed (1)
No votes
If you haven't been watching the thread in "Working With...", the only way to draw a line tangent to two arcs or circles is by using the geometric constuction methods we learned when we were drafting on the board -- there is no way to do it using the tangent snap in AC. :roll: This would be a useful addition in future AC releases.
User avatar
By Roolio
You are of course 100% correct.

More to the point drawing and arc between 2 arcs to the tangents of each of those arcs does not work either. It cannot be that hard to do can it, I mean if you can do it using a drawing board...?