The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Any 2D tool what you need for drafting.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, Gordana Radonic, nbalogh, mnguyen, gkmethy

What's your opinion about this wish?

Essential (5)
No votes
0%
Important (4)
1
100%
Average (3)
No votes
0%
Not important (2)
No votes
0%
Not needed (1)
No votes
0%
User avatar
By Jay Rennemeyer
#2519
I've been doing 2D details all week and the most annoying thing I've run into is that polylines will not trim using the Ctrl + Click method. Lines, circles, arcs, walls -- almost everything else will trim with Ctrl + Click, but not polylines.

Running a close second is the fact that you can't Unify a line or polyline into an existing polyline. AC turns the new segments into a polyline, but they won't be connected to the original polyline. You can unify all day without success. The only way to get all the segments unified into a single polyline is to explode all the polylines you are unifying, then unify the resulting line segments.
User avatar
By Aussie John
#2907
Also, dragging an edge of a polyline and seeing it change its length is annoying ( understandable since the polyline is just a fill with edges omitted)