The Global ARCHICAD Community

[ricardord]

Hi,

It used to be possible to "Clean Wall & Beam Intersections" when drawing a wall.
Now, when I click the first point the "Clean Wall & Beam Intersections" option is no longer available (it's greyed-out).

Is it not possible to bring this option back?

Thanks,
Ricardo

[Barry Kelly]

It makes no difference to how the walls actually connect.
All it does is show the connection on or not in plan view.
There is no need to change it while drawing a wall.

Generally you will want to leave it on all the time so the connections display correctly.
But if you want to see the true wall extents with no auto-connections, then you can turn it off.
But I would say you would rarely want to do that.

Barry.

[Christophe Fortineau]

I think you should try to check if you groups are enable or if your selection deals with a element about a module