The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Plot Control, Publishing, Import-Export (DXF/DWG, PDF...), IFC…

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

What's your opinion about this wish?

Essential (5)
2
67%
Important (4)
1
33%
Average (3)
No votes
0%
Not important (2)
No votes
0%
Not needed (1)
No votes
0%
User avatar
By Roolio
#23954
Clarify the plot orientation options in the plot setup window. The symbols that are there are at best unclear, there are people in our office with many years experience that can't even remember what these mean until they play with them a bit.

Amalgamate all printer and plot options into one window with tabs at the top for each separate window - yes like in Autocad (see example).

A warning or 'number of sheets' notification if you are going to plot more than one sheet (by mistake), we waste so much paper because a plot margin is not set-up absolutely 100% correct.

Thanks,

Roolio
Attachments
plot.jpg
User avatar
By Roolio
#24050
Isn't this the wish forum, looks like they have just split it up into sub-categories.

Roolio
#24051
Roolio wrote:Isn't this the wish forum, looks like they have just split it up into sub-categories.
Indeed it is. Good for you for switching to the new organization! (Since I read via the 'messages since last logged in' search, I was a little confused at first like Red. So, a meta-wish to the moderators: perhaps each of the new "wish" forums could have " Wishes" appended to the name so that it is clear when searching/etc that it is indeed a wish and not discussion forum. So, this one would be: "Publishing Wishes". :idea:

And, now back to Roolio's wish...

Karl