The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Discussions about managing Archicad in architectural practices (Project Setup, Templates, Attributes, Migration, Compatibility with Previous Versions, Preferences/Work Environment, User/Project/Application Administration/Management etc.)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, Gordana Radonic, nbalogh, mnguyen, gkmethy

User avatar
By reidweber
#324028
What are the best practices for the Open and Repair function?

I've been working on keeping the main file I use a template as clean / lean as possible. When I start a new project or even working midway through one, I've been doing the Open and Repair and early on the "project was healthy" now I receive the message "The project has been repaired, but some data are now changed or missing". As a double check, I then save and close that file and open it again with the repair function and again I receive the same "repaired- data changed or missing" window. Is the best practice to keep opening the file this way until the window pops up that the project is healthy? I've gone through the process 4+ times.

I've read through some forums about keeping the file clean/healthy. Currently there aren't any "error" messages that pop up from views, but over the course of the project, I've been seeing it happen and would like to at nip the problem in the bud.
Attachments
Open and Repair Archicad.png
Open and Repair Archicad.png (7.23 KiB) Viewed 166 times