- Tue Aug 24, 2010 10:38 pm
#180677
I have created a few electrical symbols that allow the symbol to be rotated
and keep the script (height script in this case) to remain the same regardless of the rotation.
The attached screen shot shows 5 Duplex outlets each advancing 45 degrees. The symbols look correct as placed, but when scheduled
they appear to have a mind of their own (first five listings in schedule)
Is there a way to control the 2d symbol in the schedule?
thanks in advance
David
and keep the script (height script in this case) to remain the same regardless of the rotation.
The attached screen shot shows 5 Duplex outlets each advancing 45 degrees. The symbols look correct as placed, but when scheduled
they appear to have a mind of their own (first five listings in schedule)
Is there a way to control the 2d symbol in the schedule?
thanks in advance
David
AC 19, 20, 21 Windows 10 64 bit, Dell T5810, Xeon 3.5GHz ( 6 Cores), 32 GB Ram, Quadro P2000 5GB