The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Any 2D tool what you need for drafting.

Moderators: ejrolon, Barry Kelly, Karl Ottenstein, LaszloNagy, Gordana Radonic, nbalogh, gkmethy, mnguyen

What's your opinion about this wish?

Essential (5)
4
17%
Important (4)
6
26%
Average (3)
3
13%
Not important (2)
1
4%
Not needed (1)
9
39%
User avatar
By rocorona
#25219
Another work around to get a filled or empty dot is using a simple line, very very short, choosing a circular arrowhead.
I must say that I don't like this kind of work, because if you have two nodes so near each other (the line ends) there is the risk to snap to the wrong point, and introduce alignment errors, that usually cames out too late...

--Roberto Corona--
User avatar
By StuartJames
#25228
Robert;

We have a library of drawing notation elements. It includes (amongst other things);
- cross (vertical) ... +
- cross (diagonal) ... x
- dot (empty) ... o
- dot (solid) ... .

I would rather _not_ have an extra button on the toolbar for this! ... or am I misunderstanding the question?

- Stuart

PS. All of which are - of course - sizeable!