The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Label, Text, Dimension, Markers...

Moderators: ejrolon, Barry Kelly, Karl Ottenstein, LaszloNagy, gkmethy

What's your opinion about this wish?

Essential (5)
15
54%
Important (4)
4
14%
Average (3)
No votes
0%
Not important (2)
1
4%
Not needed (1)
8
29%
User avatar
By ejrolon
#255893
Int_Skylined wrote:
Next, adding 1 new rounding option (5/10mm) in "Dimension Options" - it's so difficult? I think that "no".


I agree with you on this but the whole point about "sloppy" is about making sure that you do the job properly and that you document were you are doing exceptions.
Last edited by ejrolon on Sat May 28, 2016 7:47 pm, edited 1 time in total.
User avatar
By Int_Skylined
#255895
Yes, the colour marking or asterisk - normal solution. Dimensions with 5 or 0 at the end needs more for convenience of builders to don't catch 1,2,3 etc mm and operates with 5 and 10 mm only.

Need the possibility to shift from actual true dimensions to rounded (for any drafts), not more. That's all.
User avatar
By LaszloNagy
#255957
Int_Skylined,

In the Dimension Settings Page of the Project Preferences Set these:
Units: meter
Decimals: 2
Extra Accuracy: 5

Or:
Units: centimeter
Decimals: 0
Extra Accuracy: 5

But you will not be able to achieve this with Units set to Millimeters.
User avatar
By Int_Skylined
#255962
laszlonagy, yes, this trick and one another (with centimeters too) are sidetracks. Would like to standard solution for millimeters...

On the whole, this is a microwish, but from that "nothing" the big whole sums.