The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Plan, Section, Elevation, Schedule, Layouting...

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

What's your opinion about this wish?

Essential (5)
1
25%
Important (4)
3
75%
Average (3)
No votes
0%
Not important (2)
No votes
0%
Not needed (1)
No votes
0%
#267646
I think a great option to enhance enormously the possibility to automate detail from wall/roof/shell/Slab is the possibility to not lose fill orientation in detail using override as now happen. If you can maintain orientation, using override you can change the fill (any fill) with an other fill with more detail. Imagine a pending ceiling, a structural wall, a roof with under structur. Using fill override you can improve detail but you need to maintain the right orientation.
Attachments
override_red_213.jpg