The Global Archicad Community

[Paopao]

Hi guys,
I have to make an inclined slab. As I can understand I can use the roof pitch tool but what abot the itersection with walls? If I use the Connect command I cut the upper part: how do I cut the bottom part without trasforming the wall into a morph?

Thanks,
PP

[Christophe Fortineau]

Hello Paopao,

Are you able to share a print screen ?

[Paopao]

Here it is. I awould like to retain the characteristics of the wall because I will have to fix doors, walls, etc...Is it possible without a morph? I want to keep the upper part of the walls.

Thanks
PP

[Christophe Fortineau]

Thanks about this picture !

You are able to connect wall with shell or roof by this way :
Right clic after selecting roof and wall and clic on "single-pan roof connection"

It is possible to connect shell/roof with wall/curtain wall too !

[Paopao]

Yes, Thank you so much Christophe!

[Christophe Fortineau]

You can notice that this operation models a lower rail at the level of the curtain wall.