The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Modeling and drafting in Archicad. (Example: How can I model a Roof soffit/fascia?)

Moderators: ejrolon, Barry Kelly, Karl Ottenstein, LaszloNagy, Gordana Radonic, nbalogh, gkmethy, mnguyen

#324037
I am trying to detail my floating stair with vertical supports. I have a 1" nosing which seems to be impacting the location of the vertical support(throwing it off center). Is there not a way to fix this so it shows properly in my building section?

I would also like to shift the stringer down a little to allow some space between the bottom of the tread and the top of the stringer on the back riser side of the tread. I was able to get the tread to show as I wanted(in the FINISH ---> FLIGHT - TREAD) but the tread plate and the vertical support were still the same distance above the stringer so there was a space between the structure of the stair and the tread.
Attachments
vertical support offset.PNG
vertical support offset.PNG (21.78 KiB) Viewed 81 times
vertical tread position.PNG
vertical tread position.PNG (20.63 KiB) Viewed 81 times