The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Tips and tricks, suggestions, problems. (regularly monitored by GSHQFAdmin)

Moderators: Barry Kelly, Karl Ottenstein, LaszloNagy, ejrolon, gkmethy, apolgar, GSHQfadmin

User avatar
By ReignBough
#217477
I am not sure where to post this but is there a way to put an inline code withing your post? The [code] tag will create a block of code (same as <pre>).

I found this from PHP BB but unable to use it here.
User avatar
By Karl Ottenstein
#217479
It used to work.... Select the code block and tap the Code button...

Code: Select allTesting
   Indented 3
   If something
      Do something
   Else
       Do something else
   Endif
End test


Seems to still work.
Last edited by Karl Ottenstein on Wed Jul 10, 2013 4:56 am, edited 1 time in total.
User avatar
By Karl Ottenstein
#217480
Make sure that when you are creating your post that there is NOT a check in the box below the message entry area for "Disable BBCode in this post". It MUST be enabled for any markup codes to be honored. You can set your default to always enable in your forum Profile.
User avatar
By ReignBough
#230830
The one I am referring to is the HTML's code-tag (<code></code>). The current BBCode's code-tag ([code][/code]) is equivalent to HTLM's pre-tag (<pre></pre>).

This is to make variables, functions, etc. on the same paragraph and not in the code box.