The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Any 2D tool what you need for drafting.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

What's your opinion about this wish?

Essential (5)
8
67%
Important (4)
3
25%
Average (3)
No votes
0%
Not important (2)
No votes
0%
Not needed (1)
1
8%
#227347
Interesting.
You can offset a copy an arc but not a full circle.
If it is a circular fill it can also be done.
Barry.
#227348
PS you can use the offset tool and magic wand but you will get two half circles instead of one full circle.
Barry.
#232556
Draw a new circle after selecting Offset from the control palette. But yes, it should work the same as for a rectangle.