The Global ARCHICAD Community

Stay informed. Get help. Share your knowledge.

Modelling and drafting in ARCHICAD. (Example: How can I model a Roof soffit/fascia?)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

#300735
Looking at this again, the risers of your oval stair all emanate from one central point.
So create a large circular stair and then adjust the stair boundaries (not the baseline - leave that circular) and you may be able to get what you want.
Add nodes to the arc and adjust the edges to match the curve of your oval.

I just had a go tracing over your image but I can't get the top point of the stair to pull down enough to match your oval.
Close but not quite.
It seems there is a limit to how yo can adjust the boundary - which I am a little surprised at.
Yours may work as you have a more accurate drawing rather than an image I copies from the forum.

An alternative would be to create a slab with an oval shaped hole and the Solid Element Operate this with the stair to cut the shape away.

Barry.
Attachments
stair_oval.jpg