The Global Archicad Community

Stay informed. Get help. Share your knowledge.

Modeling and drafting in Archicad. (Example: How can I model a Roof soffit/fascia?)

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, gkmethy

By holmarch
#310314
I am having the following issues with openings using both the empty window and the opening tool

The 2d representation of an opening does not match the 3d model. Plus there are lines on the floor plan which should not be there. And it cuts through the floor finish, which should be seamless.

Is there a better method to show an opening in a wall?

Both are shown.
Attachments
2d.JPG
2d.JPG (12.67 KiB) Viewed 288 times
3d.JPG
2da.JPG
2da.JPG (11.13 KiB) Viewed 288 times
3da.JPG
#310434
Is it possible for you to just not put a Wall there?
Or create the Opening by placing the base of the Wall at the top of the intended Opening.

WallBottomAt2400mm.png
#310477
When using the "Rectangular Door Opening" is the Wall closure "Show in 3D" box checked?
Attachments
Screen Shot 2020-05-05 at 10.04.03 AM.png