The Global Archicad Community

Stay informed. Get help. Share your knowledge.

White Surface

Producing imagery with Archicad or 3rd party products; Surfaces; Lighting; Cameras; Artlantis/Cinema 4D/Maxwell etc.

Moderators: Karl Ottenstein, LaszloNagy, ejrolon, Barry Kelly, Gordana Radonic, nbalogh, mnguyen, gkmethy

 Reply
User avatar

White Surface

By Jiffy
-  Fri Nov 20, 2020 5:49 pm #319210
Hi!
The Ceiling white surface on wall turns grey instead of white on 3d section/elevation. Is there way to make it white?
Thanks.
Attachments
(30.18 KiB) Downloaded 12 times
User avatar

Re: White Surface

By Karl Ottenstein
-  Sat Nov 21, 2020 12:08 am #319217
The image that you attached seems to just be a shaded, section view - which does not even use the surface materials, but rather just colors.

If you are talking about a shaded section (my guess from the linework for the insulation fill) rather than a rendered section ... then I'll move this thread out of the Rendering forum and into the Construction Documentation forum.

For a shaded section, you can set your section settings as shown in the attached for Uncut Elements. If you change your setting to "Own Surface Colors (Non-Shaded)" your walls will appear as white. I would wager that your setting is on "(Shaded)" at the moment.
Attachments
Screen Shot 2020-11-20 at 4.03.50 PM.jpg
Screen Shot 2020-11-20 at 4.03.50 PM.jpg (126.97 KiB) Viewed 100 times
 Reply
 Return to “Presentation - Rendering and Multimedia”